Tool Grips and Tethers are a part of an overall fall protection plan to reduce the risk of falling objects and increase workplace safety. When working at-heights, it’s essential to tether tools. Tool Grips and Tethers are a piece of safety equipment with defined weight limits, built for secure attachment to tools. The plated D-ring acts as a captive hole for tethering tool lanyards. Easy to use by any worker to avoid accidentally dropping objects that could cause unwanted damage, injuries or possibly death. Rigorously tested and third party certified to a specified weight maximum capacity with a 2:1 safety factor to prevent falling objects. When working at heights, choosing the best tool tethering equipment matters because there are no second chances. Meets the ANSI/ISEA 121-2018 standard 3780 Power Tool Trap securely wraps around the battery portion of drills, impact drivers and other cordless power tools. D-Ring connection point attaches to a lanyard to prevent drops. Small fits cordless power tool batteries up to: 3.5in L x 2.75in W x 2.5in H Large fits cordless power tool batteries up to: 5in L x 3.5in W x 3.5in H 3745 Grips install onto screwdrivers and nut drivers to create a retrofit attachment point for tethering tools up to 1lb., preventing dropped or falling objects from occurring on the job. Connection points for tool lanyards can be tricky to find, especially on smaller hand tools like screwdrivers and nut drivers. While working at heights, it is important to tether tools as part of your overall fall protection plan, but the lack of these connection points can make that difficult. The sleeve features a textured rubber and is ergonomically designed to cover the entire tool handle and the end cap features a swiveling connection point for tool tethering. This tool attachment grip can be installed, removed and re-installed multiple times. Compatible with screwdrivers or nut drivers with handles ranging from 1” to 1.28” in diameter and a handle height of 4.5”. 3700 Web Tool Tether Attachments act as a retrofit attachment point on tools, belts, harnesses or structures that can be used to tether small hand tools up to 2lbs and prevent dropped or falling objects from occurring on the job. Once the base of the tail is securely taped to the tool or anchor point, the plated D-ring acts as a captive hole for tethering tool lanyards. For best use, tape the loop end of the tool tail with Squids Self-Adhering Tape. These attachments are third-party certified to 2lbs maximum capacity. Available in five lengths. Short: 3.5” , Medium: 4.5” , Long: 5.5”, X-Long: 6.5”, 2X-Long: 8.5” (XL & 2X only avail in variety pk)